A leak in the plumbing is a common home problem. Leaks can be the result of a burst pipe, cracked pipe, leaking faucet or shower head, and more. When you have a leak that requires the services of a plumber, it is essential that you stop it right away before the water causes damage to the home or causes a drastic increase to your water bill. Only then should you call a plumber in DeKalb County, GA .
The following is a guide on stopping a leak until the plumber arrives to fix it:
Once you detect a water leak, the first thing you should do is turn off the main water valve. This will stop the water from continuing to leak and causing more of a mess. The main water valve is located near the water meter. Once you have turned off the main water valve, open the faucet to allow the pressure to decrease. The remaining water in the pipes will flow through and once there is no more water pressure, there will be no pressure to push any remaining water through the damaged pipe or damaged plumbing fixture.
Once you have successfully stopped the water leak, contact the plumber. If the pipe leak is small enough, there are measures you can take to temporary stop the leak until the plumber arrives to fix it. The following is a guide on temporary fixing leaky pipes:
Epoxy: You can use epoxy to stop a leaky pipe. It is effective for sealing leaks at pipe fittings and joint fittings. Make sure the water has drained and the area is dry before sealing the leak. Also, you should clean it with steel wool. Use plenty of epoxy and then wait for it to cure.
Duct Tape or Electrical Tape: You can temporarily stop a pipe leak by wrapping electrical tape and duct tape around the crack in the pipe. Make sure the pipe is drained and dry and then wrap it tight around the pipe until the leak is completely covered. Make sure that you start wrapping a few inches away from the leak and then continue down the pipe until you are 2 inches past the leak to ensure you have adequately covered the leak. It should be wrapped a few times and make sure that each wrap is completely tight.
Pipe Clamp: To fix a big crack, get a pipe clamp and a piece of bicycle tire tubing. First, cut the tube so that it is big enough to fit around the crack causing the leak. Take a pipe clamp and secure the tube around the leak. The tube will contain the leak until the plumber arrives.
C-Clamp and Blocks: First, place a rubber pad over the leak area. Then, place a small wooden strip on top of it. Use the c-clamp to hold it all in place. The wooden strip will protect the pipe from the pressure of the c-clamp.
These repairs might stop a leak for a few days, but it is essential that you contact a professional plumber who will be able to permanently fix the leak.
Article Source: http://EzineArticles.com/5003821